| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657 |
- # Waveshare ESP32-S3-Touch-LCD-1.54 defaults
- # Override generic board selection (loaded via sdkconfig.defaults.esp32s3)
- CONFIG_BOARD_ESP32S3_GENERIC=n
- CONFIG_BOARD_WAVESHARE_ESP32S3_TOUCH_LCD_154=y
- CONFIG_ESPTOOLPY_FLASHSIZE_16MB=y
- CONFIG_ESPTOOLPY_FLASHSIZE="16MB"
- CONFIG_SPIRAM_MODE_OCT=y
- # GPIO48 is the CST816S touch interrupt on this board.
- CONFIG_LED_RGB_GPIO=-1
- # Display — ST7789 SPI TFT (240x240)
- CONFIG_DISPLAY_ENABLED=y
- CONFIG_DISPLAY_DRIVER_ST7789=y
- CONFIG_DISPLAY_BUS_SPI=y
- CONFIG_DISPLAY_SPI_CLK=38
- CONFIG_DISPLAY_SPI_MOSI=39
- CONFIG_DISPLAY_SPI_CS=21
- CONFIG_DISPLAY_SPI_DC=45
- CONFIG_DISPLAY_SPI_RST=40
- CONFIG_DISPLAY_BL_GPIO=46
- CONFIG_DISPLAY_ST7789_WIDTH=240
- CONFIG_DISPLAY_ST7789_HEIGHT=240
- CONFIG_DISPLAY_ST7789_GAP_X=0
- CONFIG_DISPLAY_ST7789_GAP_Y=35
- # ES8311 DAC
- CONFIG_DAC_ES8311=y
- # I2S pins for ES8311 (overrides generic esp32s3 defaults)
- # Signal names below are from the CODEC's perspective:
- # IO11 = ASDOUT (codec ADC out -> ESP32 in), IO12 = DSDIN (ESP32 out -> codec DAC in)
- # So the ESP32's data-OUT (DAC audio) must go to the codec's DSDIN = GPIO12.
- # IO8=MCLK, IO9=BCLK, IO10=LRCK, IO12=DOUT(ESP32->codec DAC)
- CONFIG_I2S_SCK_IO=8
- CONFIG_I2S_BCK_IO=9
- CONFIG_I2S_WS_IO=10
- CONFIG_I2S_DO_IO=12
- CONFIG_I2S_GND_IO=-1
- # Buttons: GPIO4=Volume+, GPIO0=Volume-, GPIO5=Play/Pause
- CONFIG_BTN_VOLUME_UP_GPIO=4
- CONFIG_BTN_VOLUME_DOWN_GPIO=0
- CONFIG_BTN_PLAY_PAUSE_GPIO=5
- CONFIG_BTN_PLAY_PAUSE_DOUBLE_CLICK=y
- # LVGL configuration
- CONFIG_LV_CONF_SKIP=y
- CONFIG_LV_COLOR_DEPTH_16=y
- CONFIG_LV_MEM_SIZE_KILOBYTES=64
- CONFIG_LV_USE_LABEL=y
- CONFIG_LV_USE_BAR=y
- CONFIG_LV_USE_THEME_DEFAULT=y
- CONFIG_LV_FONT_MONTSERRAT_14=y
- CONFIG_LV_FONT_MONTSERRAT_16=y
- CONFIG_LV_FONT_MONTSERRAT_24=y
- CONFIG_LV_FONT_DEFAULT_MONTSERRAT_14=y
|
