ESP32/sdkconfig.defaults.esp32s3

# ESP32-S3 target defaults - default to ESP32-S3 Generic board
CONFIG_BOARD_ESP32S3_GENERIC=y
CONFIG_ESPTOOLPY_FLASHSIZE_16MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="16MB"
CONFIG_SPIRAM_MODE_OCT=y

# USB Audio Class defaults for the current usb_device_uac integration.
# Keep both streams stereo at 48 kHz so the UAC descriptors, feedback,
# and AirPlay USB backend all use the same resampled output rate.
CONFIG_UAC_SPEAKER_CHANNEL_NUM=2
CONFIG_UAC_MIC_CHANNEL_NUM=2
CONFIG_UAC_SAMPLE_RATE=48000

# GPIO defaults
CONFIG_BAT_CHANNEL=7
CONFIG_LED_RGB_GPIO=48
CONFIG_I2S_SCK_IO=8
CONFIG_I2S_BCK_IO=11
CONFIG_I2S_WS_IO=13
CONFIG_I2S_DO_IO=12
CONFIG_I2S_GND_IO=14

# ST7789 TFT display support is not enabled by default.
# The display is optional hardware — enabling it configures specific SPI
# GPIO pins which may conflict with other peripherals on your board.
# To enable, add the following to your own sdkconfig.defaults.esp32s3
# or run: idf.py menuconfig -> Display Configuration
#
# CONFIG_DISPLAY_ENABLED=y
# CONFIG_DISPLAY_DRIVER_ST7789=y
# CONFIG_DISPLAY_BUS_SPI=y
# CONFIG_DISPLAY_SPI_CLK=18
# CONFIG_DISPLAY_SPI_MOSI=17
# CONFIG_DISPLAY_SPI_CS=15
# CONFIG_DISPLAY_SPI_DC=16
# CONFIG_DISPLAY_SPI_RST=21
# CONFIG_DISPLAY_BL_GPIO=38
# CONFIG_DISPLAY_UPDATE_MS=500
#
# LVGL configuration (required when display is enabled):
# CONFIG_LV_CONF_SKIP=y
# CONFIG_LV_COLOR_DEPTH_16=y
# CONFIG_LV_MEM_SIZE_KILOBYTES=64
# CONFIG_LV_USE_LABEL=y
# CONFIG_LV_USE_BAR=y
# CONFIG_LV_USE_THEME_DEFAULT=y
# CONFIG_LV_FONT_MONTSERRAT_14=y
# CONFIG_LV_FONT_MONTSERRAT_16=y
# CONFIG_LV_FONT_MONTSERRAT_24=y
# CONFIG_LV_FONT_DEFAULT_MONTSERRAT_14=y
#
# See components/display/README.md for full setup instructions.