# Waveshare ESP32-S3-Touch-LCD-1.54 defaults
# Override generic board selection (loaded via sdkconfig.defaults.esp32s3)
CONFIG_BOARD_ESP32S3_GENERIC=n
CONFIG_BOARD_WAVESHARE_ESP32S3_TOUCH_LCD_154=y
CONFIG_ESPTOOLPY_FLASHSIZE_16MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="16MB"
CONFIG_SPIRAM_MODE_OCT=y

# GPIO48 is the CST816S touch interrupt on this board.
CONFIG_LED_RGB_GPIO=-1

# Display — ST7789 SPI TFT (240x240)
CONFIG_DISPLAY_ENABLED=y
CONFIG_DISPLAY_DRIVER_ST7789=y
CONFIG_DISPLAY_BUS_SPI=y
CONFIG_DISPLAY_SPI_CLK=38
CONFIG_DISPLAY_SPI_MOSI=39
CONFIG_DISPLAY_SPI_CS=21
CONFIG_DISPLAY_SPI_DC=45
CONFIG_DISPLAY_SPI_RST=40
CONFIG_DISPLAY_BL_GPIO=46
CONFIG_DISPLAY_ST7789_WIDTH=240
CONFIG_DISPLAY_ST7789_HEIGHT=240
CONFIG_DISPLAY_ST7789_GAP_X=0
CONFIG_DISPLAY_ST7789_GAP_Y=35

# ES8311 DAC
CONFIG_DAC_ES8311=y

# I2S pins for ES8311 (overrides generic esp32s3 defaults)
# Signal names below are from the CODEC's perspective:
#   IO11 = ASDOUT (codec ADC out -> ESP32 in), IO12 = DSDIN (ESP32 out -> codec DAC in)
# So the ESP32's data-OUT (DAC audio) must go to the codec's DSDIN = GPIO12.
# IO8=MCLK, IO9=BCLK, IO10=LRCK, IO12=DOUT(ESP32->codec DAC)
CONFIG_I2S_SCK_IO=8
CONFIG_I2S_BCK_IO=9
CONFIG_I2S_WS_IO=10
CONFIG_I2S_DO_IO=12
CONFIG_I2S_GND_IO=-1

# Buttons: GPIO4=Volume+, GPIO0=Volume-, GPIO5=Play/Pause
CONFIG_BTN_VOLUME_UP_GPIO=4
CONFIG_BTN_VOLUME_DOWN_GPIO=0
CONFIG_BTN_PLAY_PAUSE_GPIO=5
CONFIG_BTN_PLAY_PAUSE_DOUBLE_CLICK=y

# LVGL configuration
CONFIG_LV_CONF_SKIP=y
CONFIG_LV_COLOR_DEPTH_16=y
CONFIG_LV_MEM_SIZE_KILOBYTES=64
CONFIG_LV_USE_LABEL=y
CONFIG_LV_USE_BAR=y
CONFIG_LV_USE_THEME_DEFAULT=y
CONFIG_LV_FONT_MONTSERRAT_14=y
CONFIG_LV_FONT_MONTSERRAT_16=y
CONFIG_LV_FONT_MONTSERRAT_24=y
CONFIG_LV_FONT_DEFAULT_MONTSERRAT_14=y